ATTO Technology 2390 Guide d'installation télécharger pdf (Page 26)

5V DC 4A Ethernet

Autodesk

Tablet

System

Power

Link

Activit

To USB extender

Autodesk Control Surface

To port 1 on USB Extender

3 If you are using more than one panel, use network cables to connect each of the panels to the network

switch.

4 If you are using the panel that includes the tablet, use a USB cable to connect the panel to a USB port

on the back of your workstation.

Configuring the Autodesk Control Surface

Assigning an IP Address to the Autodesk Control Surface

After you have connected the Autodesk Control Surface, you must assign it an IP address.

To configure the IP address on workstations:

1 Click Start | Settings | Network Connections.

NOTE You can also access Network Connections from the Control Panel.

2 Right-click the port that the Control Surface switch or panel is connected to and choose Properties.

20 | Chapter 3 Connecting Peripherals

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Pas de commentaire

ATTO Technology 2390 Guide d'installation Page 26