ATTO Technology Diamond Storage Array V-Class Instructions d'exploitation télécharger pdf (Page 75)

You must use a

SaveConfiguration Restart

command to implement the rebuild priority

command.

To synchronize mirrored drives manually

1 Connect to Diamond Storage Array services via

the RS-232 port or the optional Ethernet

management services card (refer to

Accessing

the Array

on page 17). You should now be in

CLI.

2 Continue with the CLI or access the RAID page

of the ExpressNAV interface (refer to

ATTO

ExpressNAV: Browser-based Interface

on page 25).

3 If

AutoRebuild has not been disabled, type

set AutoRebuild disabled saveconfiguration

restart.

4 After the array reboots and completes its

diagnostics, enter the CLI and type

RAIDManualRebuild L S where L is the LUN

and S is the sled to be rebuilt.

This procedure may take a few hours,

depending on the size of the LUN.

5 To check the rebuild status, type

RAIDRebuildStatus

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 116 117

Pas de commentaire

ATTO Technology Diamond Storage Array V-Class Instructions d'exploitation Page 75