ATTO Technology 2390D Guide d'installation télécharger pdf (Page 37)

Installing the DKU and the

AJA OEM-2K Firmware

Topics in this chapter:

■

Installing the DKU on page 29

■

Upgrading the AJA OEM-2K Firmware on page 30

Installing the DKU

Before installing your software, you must install the required version of the DKU . See the Release Notes for

the required DKU version for this version.

For major releases, the DKU is available on optical media or as a download from Autodesk. For extensions

and service packs, the DKU is only available for download. The download linkis provided in the release

announcement you received from Autodesk.

To install the DKU:

1 Open a terminal and log in as root.

2 If you are upgrading an existing application, check the currently installed DKU version by typing:

head -n1 /etc/DKUversion

If the DKU version output by the command does not match the version required for the new application

version, perform the remaining steps in this procedure.

3 Access your DKU installation package:

■ If you are installing from an application disc, insert and mount the disc using the command:

mount /dev/cdrom

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 107 108

Pas de commentaire

ATTO Technology 2390D Guide d'installation Page 37