Atto-technology Diamond Storage Array VT-Class Manuel d'utilisateur télécharger pdf (Page 32)

ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual

4.3 Ethernet Access: Telnet and SNMP Protocols

The optional 10/100 BaseT Ethernet port provides Telnet- or SNMP-based monitoring and management.

The 10/100 Base T Ethernet management services

card provides Telnet-based monitoring and

management, including firmware update using

FTP.

Remote system monitoring is also available using

Simple Network Management Protocol (SNMP).

An agent resides in the Diamond-VT which takes

information from the Array and translates it into a

form compatible with SNMP. If certain conditions

arise, the agent sends asynchronous notifications

(traps) to a client.

To connect to the Ethernet port

1 Connect a cross-over cable (for a direct

connection to a PC) or regular network cable

from a network device to the optional RJ45

Ethernet port on the Ethernet management

card on the front of the Diamond-VT.

2 If using a direct connection, power on and boot

up the host computer.

3 Attach a DB-9 null modem serial cable (the

cable must be no longer than three meters)

from the RS-232 port of the Diamond Array to a

host computer and open a terminal emulator

program on the host to set the Ethernet

parameters.Turn on the Diamond-VT.

4 First time use: Upon successful power up and

diagnostics, set the host computer with the

appropriate settings.

The host computer must have appropriate

network settings to allow it to communicate with

the Diamond-VT. Please see your system

administrator for more information.

To use Telnet

1 If you have not already done so, change the IP

address from the default by first accessing the

serial connection and using the CLI.

You may change the IP address to a network

specific value or, if the local network uses

DHCP, you may enable automatic IP

addressing (set IPDHCP enabled) using the

CLI.

2 Open a Telnet session on the host computer.

• IP address

• Port type: telnet

• Terminal type: vt100

3 If you make any changes to the network setting

on the Diamond Array, use the

SaveConfiguration Restart

command.

4 Username/password: You are prompted for a

username and password, up to eight characters

each, case insensitive. Only one

username/password combination is available

per Diamond-VT.

• You may change the telnet username and/or

password after entering a CLI session using

the commands

set TelnetUsername [username]

set TelnetPassword [password]

• Or you may change the telnet username

and/or password using the Configuration

page of the ExpressNAV interface.

• The default username is telnet and default

password is diamond

5 In the Command Line Interface mode, see a list

of available commands by typing help at the

Ready prompt or refer to

Summary of CLI

Commands

on page 29.

6 Using the ExpressNAV interface, configure the

unit as RAID Level 10 or RAID Level 5 with

zones and/or Hot Spare sleds as described

later in the manual.

To use SNMP

1 Enter the Command Line Interface through the

serial port or Ethernet.

2 Change the IP address to a network specific

value or, if the local network uses DHCP,

enable automatic IP addressing.

3 Set the number of trap client addresses by

typing set SNMPTrapAddress [1-6]

[IPAddress] [Level]

4Type set SNMPUpdates enabled.

5Type set SNMPTraps enabled.

6Type SaveConfiguration restart to reboot the

Diamond-VT.

7 Install SNMP management software on each

client you wish to receive traps (messages).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Atto-technology Diamond Storage Array VT-Class Manuel d'utilisateur Page 32

Commentaires sur ces manuels