Atto-technology Diamond Storage Array VT-Class Manuel d'utilisateur télécharger pdf (Page 48)

ATTO Technology Inc.

6.5 Serial Port Configuration Commands

The serial port configuration may be customized by using the following commands:

SerialPortBaudRate

Sets the baud rate the Diamond Storage Array uses for its

terminal interface. Choices are 2400, 9600, 19200,

38400, 57600, 115200.

Default: 115200

Set syntax: set SerialPortBaudRate [2400 | 9600 | 19200

| 38400 | 57600 | 115200]

Get syntax: get SerialPortBaudRate

SerialPortEcho

Controls whether the Diamond Storage Array echoes

characters on its RS-232 port. Local ASCII terminal (or

terminal emulator) echo settings should be set to disabled

while in serialportecho enabled

Default: disabled

Set syntax: set SerialPortEcho [enabled | disabled]

Requires a SaveConfiguration Restart command

Get syntax: get SerialPortEcho

SerialPortHandshake

Describes which handshaking method the Diamond

Storage Array uses for its terminal interface (hardware,

Xon/Xoff or none). Choices are

hardware, Xon

none

Default: none

Set syntax: set SerialPortHandshake [hard| Xon| none]

Requires a SaveConfiguration Restart command

Get syntax: get SerialPortHandshake

SerialPortStopBits

Configures/reports the number of stop bits per character

for the Diamond Storage Array RS -232 serial port. The

number of data bits per character is fixed at 8 with no

parity. Choices are 1 or 2 stop bits

Default: 1

Set syntax: set SerialPortStopBits [1 | 2]

Requires a SaveConfiguration Restart command

Get syntax: get SerialPortStopBits

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 95 96

Pas de commentaire

Atto-technology Diamond Storage Array VT-Class Manuel d'utilisateur Page 48